For barometric correction or load on normally aspirated engines

The ECU needs an input of engine load. The Omex ECU can use an input of either throttle position or manifold absolute pressure (MAP). Most normally aspirated engines will use an input of throttle position as this gives excellent throttle response. Forced induction engines need to use MAP as there is no direct relationship between throttle angle and engine load due to the variable of boost pressure. However, forced induction still requires throttle position sensor (TPS) input for idle condition information. In some cases a MAP sensor can be used on a normally aspirated engine for load.
The rating of MAP sensors is absolute, not boost pressure. Therefore a 2bar sensor is for up to 1bar boost and a 3bar for up to 2bar boost. Normally aspirated engines if using manifold pressure for load would use a 1bar sensor.

MAP sensor 1 bar

  • Merk: Omex
  • Model: OMEM2100
  • Beschikbaarheid:
    Op voorraad
  • 127,45€
  • Excl. BTW: 105,33€

Gerelateerde producten

Omex 600 Mappable Engine Management System

Omex 600 Mappable Engine Management System

600 Series ECU 4 cylinder single or dual coil ignition, semi-sequential fuelling ECU • Semi-sequential fuel injection for up to 4 cylinder engines • Distributorless or distributor ignition for..

887,91€
Excl. BTW: 733,81€

Omex 710

Omex 710

710 Series ECU Up to 12 cylinder sequential ECU Professional level Engine Management System • Suitable for up to 12 cylinder engines • Up to 12 cylinder distributorless (DIS) or 6 cylinder ‘co..

1.432,00€
Excl. BTW: 1.183,47€